Thursday, April 1, 2010

Basic Kegarator Overview

Kegarator, Kegerator, or Keg-O-Rator, no matter how you spell it means savings.

What is a kegarator? A kegarator is a refrigerated draft beer dispenser. You can buy a commercially built kegerator or build one out of an old refrigerator. The principles are still the same.

You need refrigeration, Co2 gas, a coupler, a regulator, some hoses and a faucet.

First things first, refrigeration is the most important factor when dealing with draft beer. Most draft beer is not pasteurized; therefore it must be kept cold at all times. It is brewed and kept at temperatures under 38 degrees to inhibit the growth bacteria.

Next you will need Co2 gas. Co2 stands for carbon dioxide which is an odorless, heavy atmospheric gas. This helps carbonate the beer and forces it through the lines and out of the faucet. Co2 is available in pressurized cylinders from local gas suppliers. These cylinders are under pressure and care should be taken not drop or damage the cylinder. Some imported beers need dual gas systems. Guinness is a good example. It needs Co2 and nitrogen to be setup. When you get into dual gases the system cost will be more.

The regulator tells the cylinder how much pressure to put into the keg, too much Co2 and the beer will be foamy, too little Co2 and it will be flat. The regulator is a small but important part of the setup. Most domestic kegs will run on about 10-12 pounds of pressure. Individual beers can vary, but this is a good rule of thumb.

The coupler is the part that attaches to the keg. This is the part that lets the gas in and beer out. The standard lever tap is what most kegs in North America use. The lever tap is as simple is it gets. It is threaded so all you do is line up the tap, twist until the threads lock the coupler onto the keg. Then pull the lever out while pushing down and let go. That's it. European and imported beer taps can be a little tricky to operate.

The hoses are pretty self explanatory. You will hoses to get the Co2 from the cylinder to the keg, and the beer from the keg to the faucet. You will need simple clamps for the hoses, because the gas and beer are under pressure. Do not forget to tighten the clamps.

The faucet is the actual place where the beer comes out. This is where you "draw" your beer. The part you pull to get the beer to come out is called the tap handle or tap marker. The art of drawing a perfect beer is not rocket science. It just takes practice. Remember to tilt the glass under the faucet so the beer runs down the side. Always pull the handle to the fully open position. As the glass starts to fill slowly move the glass into the upright position as the beer is pouring. A beer with 3/4 to an inch of foam is perfect.

One more thing, when you pickup your keg of beer, and bring it home. It is best to let it sit and "settle" for a few hours before you tap it. Just like a can of beer, the more it is shaken the more it will foam when you draw it. This might cause you to think that your system is working properly.

Keg beer is a great alternative to package beer. It will not take long for a draft system to pay for the initial cost setup. If you would like more information on draft beer systems go to: http://www.squidoo.com/kegarator.

Article Source: http://EzineArticles.com/?expert=Kim_Horton

No comments:

Post a Comment

Sponsor Links